Home Safety Tips: Garage Door Safety

  

Are you a mom who is concerned about your kids getting stuck underneath the garage door coming down on top of them? If your answer is 'yes', you have to be concerned about it.

The garage door is the largest movable item in your house. There is various safety features built right into it. There are electric sensors usually place on the bottom side of it. If anything breaks that beam while the door is closing then the door automatically stops and reverses and goes back. Additionally, there's a contact sensor which means, if it comes down and makes contact with anything in its way it'll stop, reverse, and go back up. It is a sensitivity setting on the unit itself.

The Consumer Product Safety Commission recommends that you check this by putting a two by four or two by eight block of wood in the pathway and then closing the garage door. What should happen, when it makes contact with that board it should stop and reverses. To understand more about garage doors, check out http://backtothefuture.wikia.com/wiki/President_of_the_United_States .

The other thing that you should check is the balance of the door. You can do that by unlatching the electric opener and then actually lifting up the door. The door can go up and down relatively smoothly even with just one hand. This is a good indication that it is balanced well.  If you were to do that and it came just crashing down and you couldn't hold it up with one hand that may indicate that your torsion spring, located on the top of the door, needs to be adjusted. It is not recommended that you adjust the torsion spring by yourself. It is advised to hire professionals. The garage door repair buffalo ny has a lot to offer for professional repairs like this. Because it is a dangerous task if you are not hundred percent sure what you're doing.

The experts and statistics tell us that little children like to touch a moving roller. The springs are called center mount springs. It is a complex mechanism. All the torque and tension is pulling against the lag screws. There are many instances where homeowners believed that when they see a lag screw is loosened they don't want to call a serviceman to pay for it. They will fix and tighten it up instead using a wrench. So when the door closed under full tension with a lag screw partially coming out, it splits out or strips out. And then that becomes a buzz saw wire. This wire is dangerous not just for your fingers and hands but for your kids as well.

It is strictly recommended to call overhead doors buffalo ny professional help.